LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting Systems - Exterior (Service Information) >> LAMP, Fog >> Removal >> Lamp

LAMP, Fog: Removal: Lamp

Fig 1: Removing/Installing Fog Lamp
GC0095266Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Raise and support the vehicle.
  3. Remove the front belly pan from the underbody. Refer to Body/Exterior/BELLY PAN - Removal .
  4. Reach behind the front fascia to access and disconnect the headlamp and dash wire harness connector (6) from the front fog lamp bulb (2) connector receptacle.
  5. Remove the two screws (5) that secure the fog lamp bracket to the back of the fog lamp seat (1) in the front fascia.
  6. Disengage the three latch features (3) of the fog lamp bracket from the opening on the back of the seat and push the fog lamp (4) forward far enough so the latch features are clear of the opening.
  7. From the face of the front fascia, remove the fog lamp and bracket from the seat as a unit.
scientia non olet · About LEMON Manuals