LAMP, Fog: Removal: Bulb

CAUTION: Do not contaminate the bulb glass by touching it with your fingers or by allowing it to contact other oily surfaces. Shortened bulb life will result.

Fig 1: Removing/Installing Fog Lamp

Courtesy of CHRYSLER LLC

Disconnect and isolate the battery negative cable.
Raise and support the vehicle.
Remove the front belly pan from the underbody. Refer to Body/Exterior/BELLY PAN - Removal .
Reach behind the front fascia to access and disconnect the headlamp and dash wire harness connector (6) from the front fog lamp bulb (2) connector receptacle.
Firmly grasp the bulb on the back of the front fog lamp housing (4) and rotate it counterclockwise about 30 degrees to unlock it.
Pull the bulb straight out from the keyed opening in the housing.