Diagnostic Test

ACTIVE DTC
1. Start the engine.
2. Allow the engine to reach normal operating temperature.
3. Turn the A/C on.
4. With a scan tool, select View DTCs.
  Is the DTC Active at this time?
  
  Yes
  - Go to step 2
  No
  - Perform the INTERMITTENT CONDITION Diagnostic Procedure. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
(C3) A/C CLUTCH CONTROL OUTPUT CIRCUIT SHORTED TO GROUND

Fig 1: Checking A/C Clutch Control Output Circuit For Short To Ground
Courtesy of CHRYSLER LLC
1. Turn the ignition off
2. Disconnect the C2 TIPM harness connector.
3. Disconnect the A/C Compressor Clutch harness connector.
4. Measure the resistance between ground and the (C3) A/C Clutch Control Output circuit at the A/C Compressor Clutch harness connector.
  Is the resistance below 100 Ohms?
  
  Yes
  - Repair the short to ground in the (C3) A/C Clutch Control Output circuit.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
  No
  - Go to step 3
A/C COMPRESSOR CLUTCH

Fig 2: Checking A/C Clutch Control Output Circuit At A/C Compressor Clutch Harness Connector
Courtesy of CHRYSLER LLC
1. Connect the C2 TIPM harness connectors.
2. Ignition on, engine not running.
3. With a 12-volt test light connected to ground, probe the (C3) A/C Clutch Control Output circuit at the A/C Compressor Clutch harness connector.
4. Using the scan tool under the TIPM Actuators, actuate the A/C Clutch.
  Does the test light illuminate brightly?
  
  Yes
  - Replace the A/C Compressor Clutch per Service Information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
  No
  - Go to step 4
TOTALLY INTEGRATED POWER MODULE (TIPM)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the A/C Clutch, TIPM, and the Powertrain Control Module (PCM).
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals. Verify that there is good pin to terminal contact in the A/C Clutch, TIPM, and Powertrain Control Module connectors.
4. Refer to any Technical Service Bulletins that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure .
  No
  - Replace the Totally Integrated Power Module per Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .