Diagnostic Test

INTERMITTENT CONDITION
1. Turn the ignition on.
2. Turn the Park Lamps on.
3. Using the scan tool, read active DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go to Step 2.
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
PARK LAMP OPERATION
1. Turn the Park Lamps off.
  Are the Park Lamps illuminated?
  
  Yes
  - Repair the (L777) Park Lamp Control Output circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Go to Step 3.
(L777) PARK LAMP CONTROL OUTPUT CIRCUIT OPEN

Fig 1: Measuring Resistance Of Park Lamp Control Output Circuit
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the TIPM C3 harness connector.
3. Disconnect the Right Front Park Lamp.
4. Measure the resistance of the (L777) Park Lamp Control Output circuit.
  Is the resistance above 10.0 Ohms?
  
  Yes
  - Repair the (L43) Left Low Beam Control circuit for an open.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Replace the Totally Integrated Power Module (TIPM) in accordance with the Service Information. Refer to MODULE, TOTALLY INTEGRATED POWER (TIPM) .
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .