Diagnostic Test

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all TIPM DTCs.
3. Turn the Headlamps on.
4. With the scan tool read the DTC information.
  Does the scan tool read: B1630-RIGHT LOW BEAM CONTROL CIRCUIT HIGH?
  
  Yes
  - Go to Step 2.
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
RIGHT LOW BEAM LAMP
1. Turn the ignition off.
2. Inspect the Right Low Beam Lamp assembly for an open condition.
  Is the inoperative bulb OK?
  
  Yes
  - Go to Step 3.
  No
  - Replace the inoperative bulb in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
(L44) RIGHT LOW BEAM CONTROL CIRCUIT
1. Turn the ignition off.
2. Disconnect the TIPM C2 harness connector.
3. Measure the resistance of the (L44) Right Low Beam Control circuit.
  Is the resistance above 5.0 Ohms?
  
  Yes
  - Repair the (L44) Right Low Beam Control circuit for a short to battery condition.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .
  No
  - Replace the Totally Integrated Power Module (TIPM) in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Totally Integrated Power (TIPM) - Standard Procedure .