LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2008 >> Sebring Convertible L4-2.4L >> Repair and Diagnosis >> Body and Frame >> Seats >> Seat Cushion >> Service and Repair >> Seat Cushion - Installation >> Front

Front







INSTALLATION





1. Set seat cushion pan into place.
2. Install wire harness fasteners to cushion frame.
3. Install seat pan cushion fasteners (1). Tighten to 11 Nm (8 ft.lbs.)
4. Connect switch wire connectors (2, 3, and 4) to the cushion side shield, if equipped.
5. Install seat back.Seat Back - Installation
6. Install cushion side shields.Seat Cushion Side Shields - Installation
7. Install seat in vehicle.Seat - Installation
scientia non olet · About LEMON Manuals