Removal

REMOVAL





1. Open hood, disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Turn the front of the left wheel inward.
4. Loosen inner splash shield enough to gain access to the washer reservoir (6).
5. Disconnect the electrical connector to the washer pump motor (4 or 5).
6. Disconnect the washer hose (1) to the washer pump (4 or 5).
7. Pull the washer pump motor (4 or 5) from the reservoir (6).

NOTE: Make sure to use a new grommet when installing a new pump, or even reinstalling the old pump back into the reservoir.