LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2008 >> Pacifica V6-4.0L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Block Assembly >> Harmonic Balancer - Crankshaft Pulley >> Service and Repair >> Vibration Damper - Installation

Vibration Damper - Installation







INSTALLATION





1. Install crankshaft damper using Special Tools C-4685-C1 (5.9 in.) Bolt (2), with Nut and Thrust Bearing from 6792, and 6792-1 (1) Installer.
2. Install vibration damper bolt. Torque bolt to 95 Nm (70 ft. lbs.).
3. Install accessory drive belt Accessory Drive Belt - Installation.
4. Install the accessory drive belt splash shield and right front wheel.
5. Lower vehicle.
6. Connect negative battery cable.
scientia non olet · About LEMON Manuals