Filling

FILLING

Remove pressure cap and fill system, using a 50/50 mix of Mopar(R) Antifreeze/Coolant, 5 Year/100,000 Mile Formula and distilled water Coolant - Description.

Continue filling system until full. Be careful not to spill coolant on drive belts or the generator. For cooling system capacity, Maintenance.

Fill coolant pressure container to at least the MAX mark with 50/50 solution. It may be necessary to add coolant to the coolant pressure container after three or four warm up/cool down cycles to maintain coolant level between the MAX and MIN mark. This will allow trapped air to be removed from the system.