Removal

REMOVAL

1. Disconnect and isolate battery negative cable from battery post.
2. Remove front floor console. Floor Console - Removal




3. Remove fastener (1), then right side front floor console closeout panel (2).




4. Remove fastener (1), then floor distribution air duct (2).




5. Remove foam isolator (3). Be sure to note how the isolator fits into place before removal for ease of reinstallation.




6. Disconnect the wiring harness connector (3) at the dynamics sensor (2).
7. Remove the nuts (1) mounting the dynamics sensor to the floor pan tunnel (4).
8. Remove the dynamics sensor (2).