LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2008 >> Pacifica V6-4.0L >> Repair and Diagnosis >> Body and Frame >> Doors, Hood and Trunk >> Trunk / Liftgate >> Trunk / Liftgate Motor >> Service and Repair >> Power Liftgate Drive Unit - Installation

Power Liftgate Drive Unit - Installation







INSTALLATION





1. Install the power liftgate drive unit assembly (1) onto the D-pillar (4).
2. Install the drive unit retaining bolts (2). Tighten the bolts to 39 Nm (28.5 ft. lbs.).
3. Connect the wire harness connector (3) to drive unit assembly (1).
4. Install the left quarter trim panel, Console Shifter Bezel - Installation.
5. Install the left rear D-pillar trim panel, Installation.
6. Install the link rod assembly, Installation for the appropriate procedure.
7. Connect the battery negative cable.
8. Using an appropriate scan tool, check and erase any power liftgate control module diagnostic trouble codes.
9. Perform the power liftgate learn cycle, Power Liftgate Learn Cycle.
10. Verify power liftgate system operation.
scientia non olet · About LEMON Manuals