Erasing Homelink(R) Transmitter Codes

ERASING HOMELINK(R) TRANSMITTER CODES

NOTE: Individual channels cannot be erased. Erasing the HomeLink(R) transmitter codes will erase ALL programmed codes.

To erase programming from the three buttons (individual buttons cannot be erased but can be "reprogrammed"), follow the step noted:

- Press and hold the two outer HomeLink(R) buttons until the indicator light begins to flash and the instrument cluster displays "Channels Cleared" (after 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink(R) is now in the train (or learning) mode and can be programmed at any time beginning with "Programming" . Programming Homelink(R) Transceiver Codes