Antenna Hardware Failure - SDARS

ANTENNA HARDWARE FAILURE - SDARS

For a complete wiring diagram Consult Diagrams/Electrical

- When Monitored:
With radio turned on.

- Set Condition:
If the antenna is connected, and the antenna has an internal failure.





Diagnostic Test

1. INTERNAL ANTENNA FAILURE
Turn the ignition off.

NOTE: Disconnect the Satellite Radio Receiver harness connector and check the related wiring terminals for corrosion, damage or terminal push out. Repair as necessary.

NOTE: Disconnect the Satellite Receiver Antenna connector and check the related wiring terminals for corrosion, damage or terminal push out. Repair as necessary.

Using the schematics as a guide, inspect the wire harness and connectors. Pay particular attention to all Power and Ground circuits.
Check the Antenna assembly for physical damage.
If there are no other possible causes, view repair.

Repair

- Replace Satellite Antenna.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test.