Throttle Body - Installation

INSTALLATION





1. Connect the PCV hose (1) to the throttle body (5).
2. Install the throttle body (5) and gasket to engine.
3. Install the PCV hose bracket and throttle body retaining bolts. Tighten to 20 Nm (15 ft. lbs.).
4. Connect the throttle body harness connector (3).
5. Install the throttle body inlet tube.
6. Install the engine cover. Align the engine cover retaining clips to the rubber mounts, and push down firmly to connect engine cover to rubber mounts.

NOTE: To ease the installation of the engine cover, apply a small amount of lubricant to the engine cover rubber mounts.

7. Connect the negative battery cable.