LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2008 >> Crossfire V6-3.2L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Drive Belts, Mounts, Brackets and Accessories >> Engine Mount >> Service and Repair >> Engine Mount - Installation >> Rear Engine Mount

Rear Engine Mount







INSTALLATION





1. Position the rear mount on the transmission.
2. Install the rear mount upper bolts (1). Tighten the bolts to 40 Nm (30 ft. lbs.).
3. Lower the transmission on to the rear crossmember.
4. Install the rear mount lower bolts (3). Tighten the bolts to 40 Nm (30 ft. lbs.).
5. Remove the transmission jack.
6. Lower the vehicle.
scientia non olet · About LEMON Manuals