Diagnostic Test

1) BODY CONTROL MODULE (BCM)
NOTE: This DTC indicates an internal BCM fault.

With the scan tool, read and record the BCM DTCs and then erase the BCM DTCs

Perform 3 ignition key cycles, leaving the ignition key on for a minimum of 30 seconds per cycle.

With the scan tool, read the BCM DTCs.

Did this DTC set again?

Yes
1. Replace the Body Control Module. Refer to REMOVAL .
2. Perform BCM VERIFICATION TEST .
No
1. The condition that caused this DTC to set is currently not present.
2. Perform BCM VERIFICATION TEST .