Ash Receiver: Removal

Fig 1: Removing Ash Receiver

Courtesy of CHRYSLER LLC

Disconnect and isolate the negative battery cable.
Remove the gear shift center bezel from the floor console (4). See REMOVAL .
Set the emergency brake and place the gear shift lever into Low gear.
Using a trim stick C-4755 or equivalent (1), remove the ash receiver (2) from the instrument panel (3) by releasing the snap retainers from the instrument panel.

Fig 2: Locating Ash Receiver Wire Connections
Courtesy of CHRYSLER LLC
If equipped, disconnect the wire harness connectors (2) from the heated seat switches and remove the switches as required. Refer to REMOVAL .
Disconnect the wire harness connector (3) from the lighter and remove the lighter assembly as required.
Remove the ash receiver from the vehicle.