Door - Front: Door: Removal
Courtesy of CHRYSLER LLC
- Disconnect and isolate the battery negative cable.
- Open the front door.
- Disengage the front door wire harness boot and connector (1) from the outside of the lower A-pillar (2).
Courtesy of CHRYSLER LLC
- Carefully pull the door wire harness boot and connector (2) out from the A-pillar far enough to access and disconnect the body wire harness connector(s) (1).
- Open the door to the full open position.
- Support the door with a suitable lifting device.
Courtesy of CHRYSLER LLC
- Remove the screw (1) from both the upper and lower front door hinges that secures the door hinge bracket (3) to the body hinge bracket (2).
- While still supporting the door, close the door to the intermediate detent position (one detent from the full open position).
Courtesy of CHRYSLER LLC
- Raise the front door (2) upward far enough to disengage the upper and lower hinge pins (3) from the pivots (1) on the upper and lower body hinge brackets.
- Remove the front door from the vehicle.