Floor Console: Removal
- Raise parking brake lever as high as possible.
- Move transmission shifter to neutral position.
- Loosen set screw on front of shifter knob and remove shift lever knob.
NOTE:
Do not use a trim stick or tool to remove transmission range indicator.
- Remove transmission range indicator bezel by squeezing the sides slightly and lifting up until the locking tabs are free of the floor console for pressure points. Refer to Fig 1.
- Disconnect transmission range indicator bezel wire connector on the underside of bezel.
- Remove screws, next to floor shifter and in console storage compartment, attaching floor console to brackets on floor pan. See Fig 2.
- Disconnect wire connector for floor console accessories at floor pan.
- Remove console from vehicle.
NOTE:
The grip portion of the parking brake lever will only fit through the wider lower portion of the slot in the floor console.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - BEZEL BOOT |
| 2 - PRNDL BEZEL |
| 3 - SHIFTER MECHANISM |
| 4 - LOCATOR PIN |
| 5 - WIRING CONNECTOR |
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - SCREWS |
| 2 - FLOOR CONSOLE |
| 3 - CLIPS |
| 4 - PARK BRAKE LEVER |