Removal - Manual - Jr-27 Only

Move seat to full forward position.
Remove rear inboard bolt attaching seat to floor pan.
Remove rear outboard bolts attaching seat to side sill pylon.
Position seat in full rearward position.
Remove front inboard and outboard bolts holding seat to floor pan crossmember. See Fig 1.
Tilt seat rearward and disconnect seat belt pretensioner wire connector.
Remove seat from vehicle.

Fig 1: Front Seat

Courtesy of DAIMLERCHRYSLER CORP.

1 - FRONT SEAT

2 - FLOOR PAN CROSSMEMBER

3 - FRONT SEAT TRACK