LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior & Exterior >> Hood >> Latch Release Cable >> Removal

Latch Release Cable: Removal

  1. Remove hood latch (Refer to BODY/HOOD/LATCH - REMOVAL) .
  2. Remove left front cowl trim panel.
  3. Remove screws attaching hood release handle to inner cowl panel. See Fig 1.
  4. Release clips attaching hood release cable to left inner frame rail. See Fig 2.
  5. Disengage rubber grommet at lower dash panel.
  6. Disengage push-in fastener attaching hood release cable to dash panel.
  7. Remove hood release cable from vehicle.
Fig 1: Hood Release Cable Handle
GC0031438Courtesy of DAIMLERCHRYSLER CORP.
1 - COWL PANEL
2 - HOOD RELEASE CABLE
3 - HOOD RELEASE HANDLE
Fig 2: Hood Release Cable Routing
GC0031439Courtesy of DAIMLERCHRYSLER CORP.
1 - FRAME RAIL
2 - UPPER RADIATOR SUPPORT CROSSMEMBER
3 - HOOD RELEASE CABLE
scientia non olet · About LEMON Manuals