LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> Sebring GTC >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Interior & Exterior >> Exterior >> Body Side Moldings >> Removal

Body Side Moldings: Removal

  1. Warm the affected body side molding and body metal to approximately 38° C (100° F) using a suitable heat lamp or heat gun.
  2. Pull body side molding from vehicle. See Fig 1.
  3. Remove adhesive tape residue from surface of vehicle.
Fig 1: Body Side Molding
GC0031408Courtesy of DAIMLERCHRYSLER CORP.
1 - QUARTER PANEL
2 - DOOR
3 - BODY SIDE MOLDING
scientia non olet · About LEMON Manuals