LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Transmission >> Manual Trans >> T350 Manual Transmission - Diagnosis & Testing & Overhaul >> T350 Manual Transaxle >> Axle Seal >> Installation

Axle Seal: Installation

  1. Clean axle shaft seal bore of any excess sealant.
  2. Align axle shaft seal with axle shaft seal bore.
  3. Install axle seal on Seal Installer 6709 and Handle C-4171 and insert into axle shaft seal bore.
  4. Tap seal into position until seated against transaxle case.
  5. Install axle shaft. (Refer to DIFFERENTIAL & DRIVELINE/HALF SHAFT - INSTALLATION)
  6. Check transaxle fluid level and adjust as necessary.
scientia non olet · About LEMON Manuals