Clutch Release Bearing: Installation

Fig 1: Clutch Release Bearing And Lever

Courtesy of DAIMLERCHRYSLER CORP.

1 - RELEASE BEARING

2 - LEVER

1. The pivot ball pocket in the lever, as well as the lever arms should be lubricated with grease prior to installation.
2. Assemble the lever to the bearing. The small pegs on the bearing must go over the lever arms.
3. Slide the bearing (1) and lever assembly (2) onto the input shaft bearing retainer, as a unit. See Fig 1.
4. Snap the clutch release lever onto the pivot ball.
5. Install transaxle,
   • For G288 M/T, (Refer to TRANSMISSION/TRANSAXLE/MANUAL - INSTALLATION) .
   • For T350 M/T, (Refer to TRANSMISSION/TRANSAXLE/MANUAL - INSTALLATION) .