Clutch Interlock/UPSTOP Switch: Removal: RHD

Fig 1: Lower Instrument Panel Bezel

Courtesy of DAIMLERCHRYSLER CORP.

1. Remove lower instrument panel bezel (2). See Fig 1.
   Fig 2: Clutch Interlock/Upstop Switch

   Courtesy of DAIMLERCHRYSLER CORP.

   1 - INTERLOCK/UPSTOP SWITCH

   2 - CLUTCH MASTER CYLINDER

   3 - CONNECTOR

2. Disconnect the master cylinder push rod from the pedal pin. Inspect push rod retainer for damage. If it is damaged (broken/cracked), it must be replaced. 
3. Squeeze together the tangs on the switch cover plate and slide the plate off the switch housing.
4. Disconnect the clutch interlock/upstop switch connector (3) from the instrument panel wiring harness. See Fig 2.
5. Remove the switch from the vehicle (1).