LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System & Automatic Transmission Cooling System >> Transmission >> Cooler-Automatic Transmission Oil >> Installation >> Turbo

Cooler-Automatic Transmission Oil: Installation: Turbo

NOTE: When the transaxle cooler lines are removed from the rolled-groove type fittings at the cooler and transaxle, damage to the inner wall of hose will occur. To prevent potential leakage, the cooler hoses and clamps must be replaced.
  1. Replace automatic transmission cooler hoses and clamps.
  2. Connect hoses to cooler, (Refer to COOLING/TRANSMISSION - STANDARD PROCEDURE) .
  3. Install transmission oil cooler and tighten screws to 8 N.m (70 in. lbs.).
  4. Install radiator closure panel center brace.
  5. Install upper radiator closure panel, (Refer to BODY/EXTERIOR/RADIATOR CROSSMEMBER - INSTALLATION) .
  6. Install grille, (Refer to BODY/EXTERIOR/GRILLE - INSTALLATION) .
  7. Start engine and check transmission fluid level. Adjust level as necessary.
scientia non olet · About LEMON Manuals