LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear Suspension >> Shock Absorber >> Removal

Shock Absorber: Removal

NOTE: Before proceeding, (Refer to SUSPENSION/REAR - WARNING) .
  1. Raise and support the vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
    Fig 1: Tire And Wheel Mounting Method
    GC0041085Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove the wheel mounting nuts (3), then the rear tire and wheel assembly.
  3. Position a transmission jack or equivalent under the center of the axle raising it enough to support the axle.
    Fig 2: REAR SHOCK MOUNTING
    GC0043363Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove the shock absorber lower mounting bolt (5), nut (7) and washer (6) at the axle (4).
  5. Remove the shock absorber upper mounting bolt (1) at the body bracket (3), then remove the shock absorber (2) from the vehicle.
scientia non olet · About LEMON Manuals