LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear Suspension >> Link-Watts >> Removal >> Upper

Rear Suspension: Link-Watts: Removal: Upper

NOTE: Before proceeding, (Refer to SUSPENSION/REAR - WARNING) .
  1. Raise and support the vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
    Fig 1: Watts Linkage System
    GC0043361Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove the cap (6) from the ball joint nut (5).
  3. Remove the nut (5) securing the link ball joint to the bell crank (9).
  4. Install Remover, Special Tool MB991113, on the link (3) ball joint at the bell crank and release the ball joint from the bell crank.
    Fig 2: WATTS LINK TO BODY ATTACHING POINTS
    GC0043370Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove the bolt (1) and nut (2) securing the link (3) to the body bracket (7). See Figure.
  6. Remove the upper link (3).
scientia non olet · About LEMON Manuals