LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Rear Suspension >> Hub / Bearing >> Removal >> Rear Disc Brake Vehicles

Rear Disc Brake Vehicles

NOTE: Before proceeding, (Refer to SUSPENSION/REAR - WARNING) .
  1. Raise and support the vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
    Fig 1: Tire And Wheel Mounting Method
    GC0041085Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove the wheel mounting nuts (3), then the rear tire and wheel assembly.
    Fig 2: REAR DISC BRAKES, HUB AND SPINDLE
    GC0041084Courtesy of DAIMLERCHRYSLER CORP.
  3. Remove the disc brake caliper guide pin bolts (4), then the caliper (1) from the disc brake adapter (3).
  4. Hang the caliper (1) out of the way using a wire hanger or bungee cord. Do not allow the caliper to hang by the flex hose; damage to the hose may occur. 
  5. Remove the brake rotor retaining clips (9), then the brake rotor (8).
  6. Remove the dust cap (10) from the hub and bearing (2).
  7. Remove the hub nut (11), then slide the hub and bearing (2) from the spindle (6).
scientia non olet · About LEMON Manuals