LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Suspension System >> Front Suspension >> Hub / Bearing >> Bar-Stabilizer >> Removal

Hub / Bearing: Bar-Stabilizer: Removal

NOTE: Before proceeding, (Refer to SUSPENSION/FRONT - WARNING) .
  1. Raise and support the vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE) .
    Fig 1: Removing/Installing Stabilizer Bar And Link
    GC0043354Courtesy of DAIMLERCHRYSLER CORP.
  2. On both sides of the vehicle, remove the stabilizer bar link assembly (3, 4, 6, 7) from the vehicle. Remove each link by holding the upper retainer/nut (3) with a wrench and turning the link bolt (7).
  3. On both sides of the vehicle, remove the stabilizer bar cushion retainer bolts (8) and retainers (9), then remove the stabilizer bar (3) with cushions attached from the vehicle.
  4. Remove the stabilizer bar (5) with cushions (10) from the vehicle.
  5. To remove the cushions (10) from the stabilizer bar (5), peel back each cushion at the slit and roll it off the bar.
scientia non olet · About LEMON Manuals