LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Steering >> Steering Linkage >> Rack & Pinion Power Steering System >> Column >> Assembly >> Ignition Switch

Ignition Switch

Fig 1: IGNITION SWITCH REMOVAL/INSTALLATION
GC0042958Courtesy of DAIMLERCHRYSLER CORP.
  1. Ensure the ignition switch is in the RUN position and the actuator shaft in the lock housing is in the RUN position.
  2. Align the ignition switch with the pin (3), actuator shaft and retaining tabs (2) located on the lock cylinder housing. Carefully install the switch snapping it into place over the retaining tabs.
    Fig 2: IGNITION SWITCH MOUNTING SCREW
    GC0042957Courtesy of DAIMLERCHRYSLER CORP.
  3. Install the ignition switch (2) mounting screw (1). Tighten the screw to 2 N.m (18 in. lbs.).
scientia non olet · About LEMON Manuals