LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Restraints >> Seat Belts >> Restraints System (Service Information) >> Rear Seat Belt & Retractor >> Installation

Rear Seat Belt & Retractor: Installation

  1. Place rear seat belt retractor into position.
  2. Install bolt attaching retractor. Tighten the retractor belt bolt to 40 N.m (30 ft. lbs.) torque.
  3. Feed seat belt and hardware through trim opening.
  4. Install lower seat belt anchor bolt. Tighten to 40 N.m (30 ft. lbs.).
  5. Install trim panel (Refer to BODY/INTERIOR/LEFT QUARTER TRIM PANEL - INSTALLATION) .
  6. Install upper and lower trim bezels.
  7. Install turning loop bolts.
  8. Install turning loop cover.
scientia non olet · About LEMON Manuals