LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Restraints >> Seat Belts >> Restraints System (Service Information) >> Passenger Airbag >> Removal >> Deployed Airbag

Deployed Airbag

Fig 1: Passenger Airbag Retaining Nuts
GC0023009Courtesy of DAIMLERCHRYSLER CORP.
  1. Open hood.
  2. Disconnect and isolate the battery negative cable.
    WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
  3. Roll/fold airbag towards instrument panel.
  4. Close door over folded airbag and tape door closed.
  5. Remove instrument panel top cover (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL TOP COVER - REMOVAL) .
  6. Open glove box, push in on the box/bin sides and lower to floor.
  7. Remove the right instrument panel end cap.
  8. Remove four passenger airbag cover screws along the bottom end of the airbag cover.
  9. Remove two passenger airbag cover screws along the top edge of the airbag cover.
  10. Remove two nuts retaining passenger airbag to instrument panel assembly inside glove box opening.
    Fig 2: Passenger Airbag Electrical Connector
    GC0023011Courtesy of DAIMLERCHRYSLER CORP.
  11. Lift airbag up until the wire connector is visible and disconnect the wire connector (1) from airbag (2). Unlock the locking tab and release the connector.
  12. Remove passenger airbag (2) from vehicle.
scientia non olet · About LEMON Manuals