LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Systems (Service Information) >> Controls >> Cable-Temperature Control >> Removal

Cable-Temperature Control: Removal

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
Fig 1: Removing/Installing Cable-Temperature Control
GC0043295Courtesy of DAIMLERCHRYSLER CORP.
NOTE: Illustration shown with instrument panel removed for clarity.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the instrument panel center bezel and disconnect the temperature control cable from the A/C-heater control, (Refer to BODY/INSTRUMENT PANEL/BEZEL-CENTER - REMOVAL) .
  3. Remove the steering column opening cover, (Refer to BODY/INSTRUMENT PANEL/COVER-STEERING COLUMN OPENING - REMOVAL) .
  4. Remove the screw (1) that secures the temperature control cable (2) to the left side of the HVAC air distribution housing (3).
  5. Disconnect the temperature control cable from the blend door pivot lever (4) and remove the cable from the vehicle.
scientia non olet · About LEMON Manuals