Cable-Mode Door: Removal
WARNING:
On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE:
LHD model shown in illustration. RHD model similar.
- Disconnect and isolate the negative battery cable.
- Remove the instrument panel center bezel and disconnect the mode control cable from the A/C-heater control (Refer to BODY/INSTRUMENT PANEL/BEZEL-CENTER - REMOVAL) .
- Remove the passenger side instrument panel silencer (Refer to BODY/INSTRUMENT PANEL/SILENCER-INSTRUMENT PANEL - REMOVAL) .
- Remove the glove box (Refer to BODY/INSTRUMENT PANEL/BIN-GLOVE BOX - REMOVAL) .
- Reach through the glove box opening and remove the two screws (2) that secure the glove box damper (3) to the instrument panel support (1) and remove the damper.
- Disengage the two retainers (4) that secure the instrument panel wire harness (5) to the instrument panel support and position the wire harness out of the way.
NOTE: Illustration shown with instrument panel removed for clarity.
- Remove the screw (3) that secures the mode door linkage cover (4) and the right floor distribution duct (2) to the right side of the HVAC air distribution housing (1).
- Disengage the mode door linkage cover from the slot at the top of the air distribution housing and remove the cover.
NOTE: Illustration shown with instrument panel removed for clarity.
- Remove the screw (1) that secures the mode control cable (4) to the right side of the air distribution housing (3).
- Disconnect the mode control cable from the mode door lever (2) and remove the cable from the vehicle.