Input Shaft: Description
WARNING: This page is about a different variant/trim than selected.
| 1 - 5TH SYNCHRONIZER |
| 2 - 5TH SPEED GEAR |
| 3 - 5TH GEAR BUSHING |
| 4 - 4TH SPEED GEAR |
| 5 - 3/4 SYNCHRONIZER |
| 6 - 3RD SPEED GEAR |
| 7 - THRUST PLATE |
| 8 - 2ND GEAR (FIXED) |
| 9 - 1ST GEAR (FIXED) |
| 10 - INPUT SHAFT |
| 11 - THRUST WASHER |
| 12 - 3RD GEAR BEARING |
| 13 - THRUST WASHER |
| 14 - BLOCKER RING |
| 15 - 4TH GEAR BEARING |
| 16 - BUSHING |
| 17 - BEARING |
| 18 - BLOCKER RING |
The input shaft assembly is part of the transaxle geartrain, is driven by the clutch assembly, and meshes with the intermediate shaft assembly. The input shaft consists of the following major components: See Fig 1.
- Input mainshaft
- Third Speed Gear
- Fourth Speed Gear
- Fifth Speed Gear
- 1st Gear (Fixed)
- 2nd Gear (Fixed)
- 3/4 Synchronizer
- 5th Gear Synchronizer
The input shaft assembly is supported by a caged roller bearing at the front of the transaxle, and a sealed roller bearing at the rear of the transaxle.