Gear Shift Boot: Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Gearshift Boot Removal/Installation

Courtesy of DAIMLERCHRYSLER CORP.

1 - GEARSHIFT BOOT

Position gearshift boot (1) over the operating lever and engage tab on mount ring at front to opening in console. Apply hand pressure to engage bosses on mount ring of boot to console opening slots. See Fig 1.

Fig 2: Gearshift Knob Removal/Installation
Courtesy of DAIMLERCHRYSLER CORP.

1 - GEARSHIFT KNOB
Position gearshift knob (1) hole over the gearshift mechanism and align the shift pattern. See Fig 2.
Verify that shift pattern is aligned properly.
Strike knob (1) with rubber mallet to engage knob to mechanism.