Diagnostic Tests
WARNING: This page is about a different variant/trim than selected.
- 1) CHECK TO SEE IF DTC P0992 IS CURRENT NOTE: The vehicle must be driven to set this DTC. The transmission must at operating temperature with the Engine RPM above 1000 RPM.
This DTC is an indication of both the 2/4 and the O/D Hydraulic Pressure Switch DTCs present.
Perform the diagnostic procedures for both P0845 and P0870.
With the scan tool, check the DTC EVENT DATA to help identify the conditions in which the DTC was set.
If there are no possible causes remaining, view repair.
Repair
- Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure(s).
- Perform 40/41 TE TRANSMISSION VERIFICATION TEST - VER 1 .