Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- 1) PCM - INTERNAL ERROR
If there are no possible causes remaining, view repair.
Repair
- Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for Service Information Tune-ups or Service Bulletins for any possible causes that may apply. If no problems are found, replace the PCM per the Service Information. With the scan tool, perform QUICK LEARN.
- Perform 40/41 TE TRANSMISSION VERIFICATION TEST - VER 1 .