Shift Mechanism

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Gearshift Knob

Courtesy of CHRYSLER LLC

1 - SHIFTER KNOB

2 - SET SCREW

Loosen set screw (2) and remove knob (1) from shifter handle. See Fig 1.

Fig 2: Removing/Installing Center Console - Typical
Courtesy of CHRYSLER LLC

1 - CENTER CONSOLE
Remove the center console assembly (1). See Fig 2.

Fig 3: Removing/Installing Shifter Bezel
Courtesy of CHRYSLER LLC

1 - BEZEL

2 - SCREW (4)
Remove shifter bezel (1). See Fig 3.

Fig 4: Identifying Interlock Cable At Shifter Assembly
Courtesy of CHRYSLER LLC

1 - INTERLOCK CABLE

2 - SHIFTER ASSEMBLY

Disconnect BTSI cable (1). See Fig 4from mechanism.

Fig 5: Identifying Gearshift Cable & Shifter Assembly

Courtesy of CHRYSLER LLC

1 - SHIFTER ASSEMBLY

2 - GROMMET PLATE NUT

3 - SHIFT CABLE

Disconnect shift cable (3) from shifter mechanism. See Fig 5.
Remove four (4) shift mechanism-to-floor pan nuts (2). Remove shift mechanism.