LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 ((40TE & 41TE Automatic Transmission - Electrical Diagnostics)) >> Automatic - 40/41TE >> DTC Troubleshooting >> P0602-Control Module Programming Error/Not Programmed >> Additional Wiring

Additional Wiring

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

For complete wiring diagrams, refer to SYSTEM WIRING DIAGRAMS article.

The controller is programmed during manufacturing process with generic software to facilitate testing. This software does not have the proper calibrations to control a transmission in a vehicle. The check for generic software is made at power-up (ignition on). If generic software is detected, the MIL will illuminate, transmission will be placed in limp-in, and will stay in limp-in even if the fault is cleared or until the proper software is installed.

scientia non olet · About LEMON Manuals