Oil Jet

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Jet O-ring

Courtesy of CHRYSLER LLC

1 - OIL JET

2 - O-RING

Inspect oil jet o-ring (2). See Fig 1.
Lightly coat o-ring (2) with clean engine oil.
Push oil jet (1) into engine block until it is fully seated.
CAUTION: Ensure oil jet is fully seated in engine block before installing fastener. Do Not use the oil jet fastener to draw the oil jet into the engine block. Damage to oil jet may occur.

Fig 2: Identifying Oil Jet Fastener - 2.4L Turbo
Courtesy of CHRYSLER LLC
Install oil jet fastener (1). Torque fastener to 12 N.m (105 in. lbs.). See Figure.
Install crankshaft. Refer to INSTALLATION .