Crankshaft Oil Seal - Front

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Crankshaft Sprocket

Courtesy of CHRYSLER LLC

1 - CRANKSHAFT SPROCKET REMOVER 6793

2 - CRANKSHAFT SPROCKET REMOVER INSERT C-4685-C2

3 - CRANKSHAFT SPROCKET

Remove the crankshaft vibration damper. Refer to REMOVAL .
Remove timing belt. Refer to REMOVAL .
Remove crankshaft sprocket (3) using Crankshaft Sprocket Remover 6793 (1) and Crankshaft Sprocket Remover Insert C-4685-C2 (2). See Fig 1.

Fig 2: Removing Front Crankshaft Oil Seal
Courtesy of CHRYSLER LLC

1 - CRANKSHAFT FRONT SEAL REMOVER 6771

2 - REAR TIMING BELT COVER

CAUTION: Do not nick shaft seal surface or seal bore.
Use Crankshaft Front Seal Remover 6771 (1) to remove front crankshaft oil seal. See Fig 2. Be careful not to damage the seal surface of cover.