LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (2.4L Engine (Service Information)) >> Cylinder Head >> Springs & Seals-Valve >> Inspection >> Valve And Valve Spring

Valve And Valve Spring

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Whenever valves have been removed for inspection, reconditioning or replacement, valve springs should be tested for correct tension. Discard the springs that do not meet specifications. The following specifications apply to both intake and exhaust valves springs:
    1. Valve Closed Nominal Tension-75 lbs. @ 38.0 mm (1.50 in.)
    2. Valve Open Nominal Tension-134 lbs. @ 29.75 mm (1.17 in.)
  2. Inspect each valve spring for squareness with a steel square and surface plate, test springs from both ends. If the spring is more than 1.5 mm (1/16 inch) out of square, install a new spring.
scientia non olet · About LEMON Manuals