LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (2.4L Engine (Service Information)) >> Cylinder Head >> Cover-Cylinder Head >> Removal >> Cylinder Head Cover

Cylinder Head Cover

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Intake Cover
GC0042787Courtesy of CHRYSLER LLC
1 - INTAKE MANIFOLD COVER
2 - MAP SENSOR
  1. Remove intake manifold cover (1).
  2. Remove upper intake manifold. Refer to REMOVAL .
  3. Remove ignition coil and spark plug wires.
    Fig 2: PCV & Make-Up Air Hose
    GC0021572Courtesy of CHRYSLER LLC
    1 - PCV HOSE
    2 - MAKE-UP AIR HOSE
  4. Disconnect PCV (1) and make-up air (2) hoses from cylinder head cover. See Fig 2.
    Fig 3: Cylinder Head Cover Tightening Sequence (Typical Cover Shown)
    GC0042786Courtesy of CHRYSLER LLC
  5. Remove cylinder head cover bolts by reversing the order shown.
    CAUTION: When removing cylinder head cover bolts, be careful not to interchange the two (2) center bolts with the seven (7) perimeter bolts. The two (2) center bolts contain an aluminum washer between the bolt head and torque limiter for sealing purposes.
  6. Remove cylinder head cover from cylinder head.
scientia non olet · About LEMON Manuals