LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (2.4L Engine (Service Information)) >> Cylinder Head >> Camshaft(S) >> Standard Procedure >> Measuring Camshaft End Play

Measuring Camshaft End Play

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Camshaft End Play - Typical
GC0021192Courtesy of CHRYSLER LLC
  1. Oil camshaft journals and install camshaft WITHOUT  rocker arms. Install rear cam caps and tighten screws to 12 N.m (105 in. lbs.).
  2. Using a suitable tool, move camshaft as far rearward as it will go.
  3. Zero dial indicator. See Fig 1.
  4. Move camshaft as far forward as it will go.
  5. Record reading on dial indicator. For end play specification. Refer to SPECIFICATIONS .
  6. If end play is excessive, check cylinder head and camshaft for wear; replace as necessary.
scientia non olet · About LEMON Manuals