LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (2.4L Engine (Service Information)) >> Cylinder Head >> Adjusters-Hydraulic Lash >> Removal >> Hydraulic Lash Adjusters

Hydraulic Lash Adjusters

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Intake Cover
GC0042794Courtesy of CHRYSLER LLC
1 - INTAKE MANIFOLD COVER
2 - MAP SENSOR
  1. Remove intake manifold cover (1).
  2. Remove upper intake manifold.
    NOTE: This procedure is for in-vehicle service with camshafts installed.
  3. Remove cylinder head cover. Refer to REMOVAL .
    Fig 2: Identifying Hydraulic Lash Adjuster
    GC0021202Courtesy of CHRYSLER LLC
    NOTE: If reusing, mark each rocker arm and each hydraulic lash adjuster for reassembly in original position. Lash adjusters are serviced as an assembly.
  4. Remove rocker arm. See REMOVAL .
  5. Remove hydraulic lash adjuster. See Fig 2.
  6. Repeat removal procedure for each hydraulic lash adjuster.
scientia non olet · About LEMON Manuals