LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Exhaust System & Turbocharger) >> Turbocharger System >> Charge Air Cooler And Hoses >> Removal >> Removal-Charge Air Cooler-Hoses >> Hose - Charge Air Cooler To Throttle Body

Hose - Charge Air Cooler To Throttle Body

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Charge Air Cooler Hoses
GC0019344Courtesy of CHRYSLER LLC
1 - HOSE - CHARGE AIR COOLER TO THROTTLE BODY
2 - CHARGE AIR COOLER
3 - HOSE - TURBOCHARGER TO CHARGE AIR COOLER
  1. Remove air cleaner housing. Refer to HOUSING-AIR CLEANER .
  2. Disconnect negative battery cable.
  3. Disconnect positive battery cable.
  4. Remove battery and battery tray. Refer to REMOVAL .
  5. Remove battery tray support bracket.
  6. Loosen hose clamp at charge air cooler (2).
  7. Dislodge hose from charge air cooler.
    Fig 2: Intake Air Temperature Sensor - 2.4L Turbo
    GC0019359Courtesy of CHRYSLER LLC
    1 - HOSE - CHARGE AIR COOLER TO THROTTLE BODY
    2 - IAT SENSOR
    3 - TIP HOSE
  8. Disconnect Inlet Air Temperature (IAT) sensor (2) connector.
  9. Disconnect Throttle Inlet Pressure (TIP) hose from charge air cooler hose (1).
  10. Loosen hose clamp at throttle body.
  11. Remove charge air cooler hose.
scientia non olet · About LEMON Manuals