LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2006 >> PT Cruiser Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Exhaust System & Turbocharger) >> Turbocharger System >> Charge Air Cooler And Hoses >> Installation >> Installation-Charge Air Cooler Hoses >> Hose - Charge Air Cooler To Throttle Body

Hose - Charge Air Cooler To Throttle Body

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Charge Air Cooler Hoses
GC0019344Courtesy of CHRYSLER LLC
  1. Position hose to mounting location.
  2. Connect hose to throttle body.
  3. Connect hose to charge air cooler.
  4. Tighten hose clamps to 1.7 N.m (15 in. lbs.).
    Fig 2: Intake Air Temperature Sensor - 2.4L Turbo
    GC0019359Courtesy of CHRYSLER LLC
  5. Connect Throttle Inlet Pressure (TIP) hose to charge air cooler hose.
  6. Connect Inlet Air Temperature (IAT) sensor connector.
  7. Install battery tray support bracket.
  8. Install battery tray and battery. Refer to INSTALLATION .
  9. Connect positive battery cable.
  10. Connect negative battery cable.
  11. Install air cleaner housing. Refer to Refer to HOUSING-AIR CLEANER .
scientia non olet · About LEMON Manuals