EVAP Canister

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Tank Assembly Components

Courtesy of CHRYSLER LLC

1 - CONTROL VALVE

2 - FUEL PUMP

3 - FLOW MANAGEMENT VALVE

4 - EVAP CANISTOR

5 - NATURAL VACUUM LEAK DETECTION VALVE

6 - FILTER

Release fuel pressure, refer to STANDARD PROCEDURE .
Remove the air cleaner lid, disconnect the inlet air temperature sensor and makeup air hose.
Remove the negative battery cable.
Raise vehicle and support.
Drain fuel tank, refer to STANDARD PROCEDURE .

Fig 2: Identifying Fuel Tank & NVLD
Courtesy of CHRYSLER LLC

1 - NVLD

2 - FUEL TANK
Remove fuel tank and EVAP system, refer to REMOVAL .

Fig 3: Identifying EVAP Canister & Push Pin
Courtesy of CHRYSLER LLC

1 - PUSH PIN
Remove the push pin.
Remove hoses from EVAP canister.

Fig 4: Identifying Spring Clips
Courtesy of CHRYSLER LLC

1 - SPRING CLIPS
Spread spring clips on the side of EVAP canister and tip canister out and away from bracket tabs.

Fig 5: Vapor Canister Bracket Tabs

Courtesy of CHRYSLER LLC

1 - TABS